The most common type of pump in use today, Centrifugal pumps are typically used to move low viscosity fluids through a piping system. There are a number of configurations available depending on the application requirements, including: end suction, split case, single and multi-stage, and vertical multi-stage units.
All types of centrifugal pumps work on the principle of converting velocity to flow and pressure. This occurs as the fluid enters the eye of the pump and is accelerated as it moves outwards through the vanes to the volute where the fluid exits the pump at a higher velocity.
C & B Equipment can offer all types and configurations to match your needs, featuring the Crane line of products, as well as others.
Vertical multi-stage process pumps, Boiler Feed and Pressure Boosting
End Suction (ANSI), Split Case, Vertical Sump, Inline (ANSI), Non-Clog Dry Pit, Vertical Sump, Vertical Process
End Suction, Inline Vertical, Split Case, Industrial Sump, Non-Clog Dry Pit, Condensate Return Units
Standard Centrifugal, Self-Priming, Vacuum Assisted Dry Prime, Industrial/Agricultural, Hydraulic Power Units, Replacement Gorman Rupp Parts
ANSI Chemical Process, Vertical In-Line, High Temperature/Heat Transfer
Horizontal and Vertical End, Suction, Multistage, Axial Split Case, Self-Priming, API, Solids Handling
Centrifugal Pumps, Close Coupled, Frame Mounted, Electric or Engine Powered
Self-Priming Pumps, Municipal and Industrial Wastewater
Seal-less magnetic drive centrifugal pump, medium-flow, medium to high head applications, ANSI sizes for efficient lower flow applications
Corken® SC-Model Side Channel Pump
The SC-model side channel pump is a mechanically sealed design and is the standard seal option for propane, butane, and agricultural ammonia service.
Corken® SCM-Model Side Channel Pump
The SCM-model side channel pump is a sealless magnetic drive design and is recommended for pumping hazardous, toxic, foul smelling, or other difficult-to-seal thin liquids.
Corken® FF- & FD-Model Turbine Pump
An F-model turbine pump is a frame mount design and requires a baseplate.
Corken® DS- & DSF-Model Turbine Pump
The DS-/DSF-model regenerative turbine pump is a direct mount design made for a standard, two pole C-Face motor with a 4.5" rabett diameter.
Corken® DL-, DLD- & DLF- Model Turbine Pump
The DL-/DLD-/DLF-model regenerative turbine pump is a direct mount made for a standard, two pole C-Face motor with a 8.5" rabett diameter.
Corken® MDC-Model Close-Coupled Turbine Pump
The MDC-model (Magnetic Drive Coro-Flo) is a stainless steel turbine pump with a sealless magnetic drive configuration.